![]() ![]() Since “YES” in unavailable, click Finish. Pick the appropriate drive, then click Next. You’re asked to identify the number and location of the CD-ROM drive you wish to use (where CD1 is located): Insert Disk A1, navigate to the EPC folder: ![]() The only inconvenience is that you would need to plug it in when you ran the program, and also that you would need to make sure that other USB devices didn’t assume the drive letter that the thumb drive assumed when the program was installed. Ken Blake offered a tip to install the catalogs onto a thumb drive (USB Drive) to work around the large disk issue. After installation, you can delete the folder. You can work around this by creating a temporary folder and copying very large files into it until you have less than 5GB free. Another problem is that the program will refuse to install the catalog (data) files on NTFS drives that have more than about 5GB of free. This is due to the fact that the software is really old. If you are installing to an NTFS-formatted drive (Windows NT, 2000, XP) you may get an error during the CD Setup phase that there is not enough drive space, even though there really is adequate space. Installing the Toyota EPC application You’re going to need at least 20 MB of free space for the program and catalog files. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |